Price:
US$53.99
Free Shipping
Happymodel CrazybeeX DXS F4 1-2S AIO 5in1 Flight Controller Built-in VTX/ DSM2 DSMX Receiver/ESC/OSD
Compatibility
To confirm that this part fits your vehicle, please enter your vehicle's details below.
-
Year:
Select
-
Make:
Select
-
Model:
Select
-
Submodel:
Select
-
Trim:
Select
-
Engine:
Select
- Clear All
This part is compatible with 0 vehicle(s).
Show all compatible vehicles
Show all compatible vehicles
This part is compatible with 1 vehicle(s) matching
This part is not compatible with
Recent searches
- Year
- Make
- Model
- Submodel
- Trim
- Engine
CrazybeeX series flight controller is the first 4in1 AIO flight controller which could handle 2s.
The CrazybeeX DXS V1.0 is the newest member which is the first flight controller built-in DSM2/DSMX compatible SPI Receiver.
It's a better upgrade for reduce the weight of your brushless whoop if you are using Spektrum transmitter. Best upgrade flight controller for Mobula6/Mobula6HD DSMX version .
Flight controller | MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1S-2S battery input (DC 2.9V-8.7V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Betaflight OSD(SPI Control) Built-in 5.8G VTX Built-in SPI Frsky receiver support D8/D16 Built-in 5V 1A BEC Built-in voltage detection Firmware version Customized Betaflight4.3.0 S411 |
Onboard 4in1 ESC | MCU upgraded to EFM8BB21 Power supply: 1-2S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7.HEX Default protocol: DSHOT600 |
Onboard DSM2/DSMX SPI receiver | SPI BUS receiver DSM2/DSMX compatible Channels: Max 12ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m RSSI enable(show on the goggles) |
Onboard 5.8g VTX | Output power: 25mw Frequency: 40CH Input voltage: 3.3V~5.5V Current consumption: 300mA(type) Frequency: 5.8GHz 5bands 40 channels With Race band Smartaudio ready Default vtx_power should set to be “3” |
Onboard Voltage and Current detector | Voltage Meter scale “110” Amperage Mete scale “1175” |
Notice: Recommend Betaflight configurator 10.7.0 version
SPI Receiver option: Spektrum
Bind procedure:
- Plug the USB then press the bind button, the red LED at the bottom of the flight controller will blinking fast , this indicate the SPI DSM2/DSMX receiver is in bind mode.
- Plug the USB then connect to Betaflight configurator, move to the CLI tab , then type “bind_rx”, the red LED at the bottom of the flight controller will blinking fast too , this indicate the SPI DSM2/DSMX receiver is in bind mode.
Package Included:
1* CrazybeeX DXS AIO 5in1 F4